Troubleshooting -
1
To add extra support to the aprons on the P1088 table. First remove the existing aprons from the table. Next remove one bolt at a time from each corner of the rail and install the apron brackets as shown in the photos. There will be two brackets per rail. Replace the bolt to attach the bracket to the bottom of the table. The bolt will only fit through one of the slots on the bracket. Make sure to push the bracket in towards the center of the table and align the bracket so the apron will rest flush against it. Tighten the bolt back as it was originally. When you replace the aprons they will not be connected to the brackets. The brackets will provide support to the aprons to keep them at the correct angle during the life of the table. (Click on the photos for larger images.)
Remove the aprons and remove one bolt at a time.
Install bracket and push bracket in.
Replace the aprons
;)
Remove the aprons and remove one bolt at a time.
;)
Install bracket and push bracket in.
;)
;)
;)
Replace the aprons
2
;)
Clean all remains of old glue form the ferrule. (Click on image for larger view)
;)
Apply felt to the cue tip brace and clamp to protect your cue. (Click on image for larger view)
;)
(Click on image for larger view)
;)
Apply a small amount of glue to the end of the cue (Click on image for larger view)
;)
Place cue in support brace and apply the support brace clamp (Click on image for larger view)
